
Kingroon KLP1Discontinued
- Speed
- 500 mm/s
- Score
- 7.6/10
- Wins
- 2/5
Discontinued. Replaced by the Bambu Lab A1.
Specs from the PrintPick catalog, checked 2026-09-29. Scores are PrintPick ratings out of 10.

Discontinued. Replaced by the Bambu Lab A1.

Buy the KP3S Pro V2.
The KLP1 scores higher but is discontinued. Underrated. Linear rails and direct drive at this price is a spec sheet that should cost twice as much. The 200mm volume is the real limitation, not the hardware quality.
Teal wins the row.
| KLP1 | Spec | KP3S Pro V2 |
|---|---|---|
| 8.0 L | Build volume | 8.0 L |
| 500 mm/s (wins) | Top speed | 250 mm/s |
| 0.05 mm | Finest layer | 0.05 mm |
| 8.5 kg | Weight | 6.5 kg |
| KLP1 | Feature | KP3S Pro V2 |
|---|---|---|
| Yes | Enclosed | No |
| Yes | Linear rails | Yes |
| Yes | CoreXY | No |
| Yes | Auto bed leveling | Yes |
| Yes | Klipper firmware | No |
| Yes | WiFi | No |
| No | Direct drive | Yes |
| No | PEI build plate | Yes |
| KLP1 | Spec | KP3S Pro V2 |
|---|---|---|
| 9 | Value | 10 (wins) |
| 6 | Beginner Friendliness | 7 (wins) |
| 8 (wins) | Print Quality | 7 |
| 8 (wins) | Speed | 5 |
| 7 | Reliability | 7 |
| 7.6 (wins) | Overall | 7.2 |
The widest gap is Speed: the Kingroon KLP1 scores 8 against 5 for the Kingroon KP3S Pro V2, a 3-point lead. The Kingroon KLP1 lists a top speed of 500 mm/s against 250 mm/s.
Enclosed CoreXY with linear rails [...]. Kingroon is building something special here.KLP1 owner, r/3Dprinting
After tuning, the KLP1 produces prints that rival machines twice the price.KLP1 owner, r/klippers
This is the budget printer the community sleeps on.KP3S Pro V2 owner, r/3Dprinting
A printer does nothing without these. Grab them in the same order.
By the numbers, the Kingroon KLP1 scores higher (7.6/10). But "better" depends on your use case, the Kingroon KP3S Pro V2 may be the smarter buy if you need budget.
The Kingroon KP3S Pro V2 is more beginner-friendly (7/10 vs 6/10) with easier setup and a gentler learning curve.
The Kingroon KLP1 scores higher overall (7.6/10 vs 7.2/10). The extra money gets you enclosed corexy with linear rails and klipper at this price: this combination normally costs $400+.
Build volume (200x200x200mm vs 200x200x200mm) and print speed (500 vs 250 mm/s). The Kingroon KLP1 is best for enclosed; the Kingroon KP3S Pro V2 targets budget.